Spypoint TINY-W2 User Manual download pdf (Page 8)

English

PROGRAMMING

Turn on the camera to navigate in the interface by pressing

“” or “” and press “OK” for selection. To modify the

selection, press “” and “” again and press “OK” to

confirm. To return to the previous menu press “”.

PHOTO

To take pictures. The “Photo” mode must be selected by

pressing “OK”; the test light in the front of the camera will

wink for 60 seconds to allow the operator to walk away from

the camera.

VIDEO

To take videos. The “Video” mode must be selected by

pressing “OK”; the test light in the front of the camera will

wink for 60 seconds to allow the operator to walk away from

the camera.

TEST

To set the camera or the distance. When “Test” mode is

selected, no picture or video is recorded. Walk perpendicularly

in front of the camera. When the camera detects movement,

the light winks to indicate that normally, a photo or video

would have been recorded. If the system does not detect

the movement, increase the distance detection using the

“Settings” menu (the option “Sensitivity” allows the user

to set the sensitivity to “High”, “Medium” or “Low”). You

can also realign the camera differently. Once you understand

how the device responds to detections, you can better adjust

the direction or the height of the camera (Recommanded

installation height: about 3 feet).

In “Test” mode, it is possible to take a picture by pressing

the “OK” button. The photo is saved and appears in

“View” mode.

SIGNAL

Wireless signal test

The quality of the wireless signal between the TINY-W

camera and the Blackbox receiver can be checked on the

camera in “Signal” mode by choosing the “Range Test”

option. If the icon of the wireless signal is red, the signal is

too weak. Bring closer or move the receiver. If the icon of the

wireless signal is green and stays green for at least 10 seconds,

the signal is strong enough and stable to enable wireless

transmission of images to the receiver. For best results, the

antennas of the two devices must point upwards and their

respective height should be approximately the same.

Note: If the receiver is not powered and synchronized with

the camera , the signal icon remains red.

Manually synchronizing one or multiple sets (TINY-W

camera + Blackbox receiver) in the same perimeter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

Comments to this Manuals

No comments

Spypoint TINY-W2 User Manual Page 8

Comments to this Manuals

Related products and manuals for Camcorders Spypoint TINY-W2